User Guide

MECHA User’s Guide v.05.4 ! Dual Axis

P-30,30,1:=0,-=0,0 then `Ok].

------8J-------------------

This preset uses the repeat feature o>ered by MECHA before the scrip!ng

features were added.

The list of angles explained

P is a conven!on in which !l!ng is like pitch in Ptgui.

A'er %rst row of 10 or 12 is made just like for a single MECHA, the repeat is

called and the list says what changes are for each repeat:

? for 1st repeat is -3; *2nd MECHA will !lt to -3;°+

? for 2nd repeat is 3; *2nd MECHA will !lt to 3;°+

then there is something di>erent: 1, which says: from now on, there is only

one posi!on per row, 1:=0 means 1 posi!on at a !lt of =0°, -=0 means 1

posi!on at a !lt of -=0°, then go back to 0° !lt.

------8J-------------------

Then you can click on [Save 1] to save and assign this preset to bu"on [1] of

MECHA-H-DAC. From now on, you can launch this preset by simply press `1]

then w *for clockwise rota!on+ when MECHA is idle, or press [1] then v *for

counter-clockwise rota!on+.

Also, you can click on [Save] bu"on to save it on MECHA, in the Presets list,

with a desired name.

DAC_14-10-8-6_Shots_7_Rows_2N_2Z_Level.mps

This is a bit in!mida!ng, but it works very well, for a pre-scrip!ng era.

Why not use it•

It is very similar with the previous one, except it shoots a di>erent number

of posi!ons per each row:

• 15 posi!ons on 1st row

• then 10 posi!ons at a !lt of -12°

• then 8 posi!ons at a !lt of - 5;°

• then 6 posi!ons at a !lt of -60°

• then 10 posi!ons at a !lt of 12°

• then 8 posi!ons at a !lt of 5;°

• then 6 posi!ons at a !lt of 60°