User Guide

• First, set up a hot-spot with the name MECHA-UPDATE and password

87654321.

• Press the power bu"on, ⏻, for about 3 to ; seconds to power up

MECHA, and wait un!l de spli#ng lights end: -=-=-=-= , there is no more

LED ac!vity and you will hear two beeps. MECHA is now in idle status

and can accept commands and codes. If MECHA doesn’t reach this

status, then please power it down, by pressing the power bu"on 3

seconds, and contact us at mecha@nodalninja.com.

• Using MECHA’s bu"ons, enter the code

312123<, by pressing one a'er

another each bu"on. Before pressing the last bu"on, you can wait and

look how the LEDs will show the entered sequence, just to be sure you

entered the correct code. If there is any mistake, short-press the power

bu"on and enter the code again, and terminate with J, by pressing the

le' arrow bu"on,v. Now, no!ce how MECHA starts scanning the

exis!ng networks, and when it connects to the previously created hot-

spot, two beeps are heard. The code

312123< will update the %rmware

using the MECHA-UPDATE hot-spot you set. The response – displayed on

the LEDs – can be: ###, if Internet is not available for MECHA.

NOTE. See the Table of equivalences: LEDs – characters.

The update may take up to ; minutes, but, in case of slow Internet

connec!on, it could take more.

Please do not turn o% MECHA while upda!ng#

MECHA User’s Guide v.05.4 ! Single Axis