User Guide

105
MECHA User’s Guide v.05.4
© 2020 FANOTEC
231J
Everything OFF, for faster ba"ery charge. First, plug the charger cable,
then enter the code.
Press the power bu"on,
⏻, to show/hide ba"ery level on LEDs when
charging.
If it’s no power on charging cable, the code will be ignored.
If the code is executed, the LEDs will show charging, then the cable has
to be unplugged and MECHA has to be powered-up again to go back to
normal use.
Pressing other bu"ons than `p] will have no e>ect.
As an alterna!ve, in UI /con#g page, When Charging op!on should be
Turn OFF.
This reduces the charging !me to minimum, and is also recommended
if MECHA is not intended to be used with charging cable inserted, to
prevent accidental rota!on of MECHA by UI commands, when charging.
232J
Disable/Enable all LEDs, useful during night photography.
As the power LED is o>, don(t forget the device turned on.
The LEDs will light however if bu"ons are pressed for entering a code, to
show the result of a code, or for ba"ery check.
It enhances the performance of MECHA DAC by using less RAM for
communica!on.
12321J
Backlash compensa!on calibra!on.
A'er the code is entered, MECHA will turn slowly to the right, then
power LED will start )ashing.
A'er that, you have to press
⏻ when you see/feel the MECHA starts
moving very slightly to the le'.
You can use the view%nder, LIVE view with zoom, other devices
a"ached, like a laser pointer, so on, or simply feel by hand when that
small movement begins.
At the end, the LEDs will show, say, 7:257, where 25 is the new
calibra!on factor *it should be around this value+.
You can repeat the code if you want to do it be"er or you have more
precise ways to determine the small movement.
You can cancel the procedure with any other bu"on when the power
bu"on,
⏻, )ashes, or press ⏻ right a'er it starts to )ash, to have no
compensa!on at all, or it will !me-out in ; minutes if no bu"ons are
pressed.