User's Manual

You will see Right Leg Power, Left Leg Power, Collective Power, Cadence, and the % of power Right to
Left.
Step 4. When exercise is complete, tap on the line that has your Cadence and Power numbers to review
Cadence, Average Peak Power and Bilateral force of each leg around the crank.
Step 5. Tap <Back to return to Cycling Dashboard.
Step 6. Tap <Exercises to return to Main Menu.
Step 7. Repeat steps 1 thru 5 to perform next Cycling event.
Standing Calibration
Step 1. Tap to go to Firmware Updates, Calibration, History, Options, Remote Running, & Symmetry Score
Step 2. Tap Calibration.
Step 3. Tap Standing Calibration.
Step 4. Enter weight and Tap Next. (the app will direct you to the calibration screen)
Step 5. Stand next to wall and place hands on wall for balance only. Do not lean on your hands. You must
Stand only on your right foot and as still as possible.
Step 6. Raise left leg. Tap start and wait for green progress bar to complete.
Step 7. Repeat process with left leg.
Instructions on Sharing the Data
Share Data
Step 1. Tap to go to Firmware Updates, Calibration, History, Options, Remote Running, & Symmetry Score
Step 2. Tap Options.
Step 3. Tap Interface.
Step 4. Tap Share Data and the number of Exercises to Share will automatically populate into an email.
Step 5. Add all addresses you wish to Share the Data with on the To: line.
Step 5. You can add extra text to the body of the email if you wish but not necessary.
Step 6. Tap Send.
Step 7. Tap Options to return to Options Menu.
Step 8. Tap then tap Exercises to go to Main Menu.
Instructions on Adding New Firmware
Step 1. Go to Options Menu
Step 2. Tap Firmware Update
Step 3. Tap “Check for Update”
Step 4. Tap “Install”. You will see each insert upload the firmware from zero to 100%.
Inserts will disconnect from Bluetooth when upload is complete.