Data Sheet

SPECIFICATION
240W Constant Power Mode LED Driver
XLG-240 se ri e s
MODEL
RATED CURRENT
RATED POWER
FULL POWER CURRENT RANGE
OUTPUT
CURRENT ADJ. RANGE
VOLTAGE RANGE Note.5
FREQUENCY RANGE
POWER FACTOR (Typ.)
EFFICIENCY (Typ.)
AC CURRENT (Typ.)
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
SAFETY STANDARDS
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
VIBRATION
MTBF
DIMENSION
OTHERS
OVER VOLTAGE
OVER TEMPERATURE
47 ~ 63Hz
2.7A / 115VAC 1.3A / 230VAC 1.1A / 277VAC
<0.75mA / 277VAC
20 ~ 95% RH non-condensing
-40 ~ +80℃, 10 ~ 95% RH non-condensing
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
830.77K hrs min. Telcordia SR-332(Bellcore) ; 219.75K hrs min. MIL-HDBK-217F (25℃)
ENVIRONMENT
PROTECTION
SHORT CIRCUIT
93% 92.5% 91%
COLD START 85A(twidth=500 s measured at 50% Ipeak) at 230VAC;μ Per NEMA 410
TOTAL HARMONIC DISTORTION
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:1.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25℃/ 70% RH
CONSTANT CURRENT REGION Note.2
PACKING
MAX. NO. of PSUs on 16A
CIRCUIT BREAKER
2 unit(circuit breaker of type B) / 4 units(circuit breaker of type C) at 230VAC
Hiccup mode or constant current limiting, recovers automatically after fault condition is removed
(Please refer to "STATIC CHARACTERISTIC" and “ DRIVING METHODS OF LED MODULE"section)
100 ~ 305VAC 142VDC ~ 431VDC
OPEN CIRCUIT VOLTAGE (max.)
380 ~ 440V
190~ 240V 61 ~ 78V
Shut down output voltage, re-power on to recovery
TEMP. COEFFICIENT
±0.03%/℃ (0 ~ 60℃)
WORKING TEMP.
Tcase=-40 ~ +90℃(Please refer to "OUTPUT LOAD vs TEMPERATURE" section)
MAX. CASE TEMP.
Tcase=+90℃
PF 0.97 / 115VAC, PF 0.95 / 230VAC full load≧ ≧ , PF≧0.92 / 277VAC at
(Please refer to " " )Power Factor Characteristic section
THD< 10% (@ load≧50% at 115VAC/230VAC ,@load≧75% at 277VAC)
Please refer to “TOTAL HARMONIC DISTORTION (THD)” section
CURRENT RIPPLE 4.0%(@ Load≥50% rated voltage)
CURRENT TOLERANCE ±4%
SET UP TIME Note.6
500ms/230VAC, 1200ms/115VAC
STANDBY
POWER CONSUMPTION
UL8750(type”HL”), CSA C22.2 No. 250.13-12; ENEC EN61347-1, EN61347-2-13 independent, EN62384;
GB19510.1,GB19510.14; EAC TP TC 004;IP67 approved
219*63*35.5mm (L*W*H)
350~1050mA
700mA
239.4W
700~1050mA
178~ 342V
370V
XLG-240 -L-
239.4W
1400mA
90 ~171V
186V
700~2100mA
1400~2100mA
XLG-240 -M-
239.6W
4900mA
27 ~ 56V
60V
2200~6660mA
4280~6660mA
XLG-240 -H-
Standby power consumption <0.5W for AB-Type(Dimming OFF)
INPUT OVER VOLTAGE Note.7
320 ~ 390VAC (Shut down output when the input exceeds protection voltage,recovers automatically after fault condition is removed)
can survive input voltage stress of 440Vac for 48 hours
Shut down O/P voltage, recovers automatically after temperature goes down
Adjustable for A/AB-Type only (via the built-in potentiometer)
1Kg;16pcs / 16Kg / 0.77CUFT
SAFETY &
EMC
(Note 8)
Parameter
Parameter
ESD
Radiated
EFT / Burst
Surge
Conducted
Magnetic Field
Voltage Dips and Interruptions
Conducted
Radiated
Harmonic Current
Voltage Flicker
EN61547
Standard
Standard
EN61000-4-2
EN61000-4-3
EN61000-4-4
EN61000-4-5
EN61000-4-6
EN61000-4-8
EN61000-4-11
Test Level / Note
Test Level / Note
Level 3, 8KV air ; Level 2, 4KV contact
Level 2
Level 3
Level 2
Level 4
>95% dip 0.5 periods, 30% dip 25 periods,
>95% interruptions 250 periods
EMC IMMUNITY
EMC EMISSION
4KV/Line-Line 6KV/Line-Earth(6K/10K option)
NOTE
1.AllparametersNOTspeciallymentionedaremeasuredat230VACinput,ratedcurrentand25 ofambienttemperature.℃
2.Pleasereferto"DRIVINGMETHODSOFLEDMODULE".
3.Ripple&noisearemeasuredat20MHzofbandwidthbyusinga12"twistedpair-wireterminatedwitha0.1uf&47ufparallelcapacitor.
4.Tolerance:includessetuptolerance,lineregulationandloadregulation.
5.De-ratingmaybeneededunderlowinputvoltages.Pleasereferto“STATICCHARACTERISTIC”sectionsfordetails.IfcontinuallyoperatewithACon/off
inshorttime,itmaycausesPWMdriverICintoprotectionstatus.
6.Lengthofsetuptimeismeasuredatfirstcoldstart.TurningON/OFFthedrivermayleadtoincreaseofthesetuptime
7.OnlyforXLG-240Iseries,andIserieswithoutUL/CSAcertificate.
8.Thedriverisconsideredasacomponentthatwillbeoperatedincombinationwithfinalequipment.SinceEMCperformancewillbeaffectedbythe
completeinstallation,thefinalequipmentmanufacturersmustre-qualifyEMCDirectiveonthecompleteinstallationagain.
9.Thisseriesmeetsthetypicallifeexpectancyof>50,000hoursofoperationwhenTcase,particularlytcpoint(orTMP,perDLC),isabout75 orless.℃
10.PleaserefertothewarrantystatementonMEANWELL'swebsiteathttp://www.meanwell.com
11.TofulfillrequirementsofthelatestErPregulationforlightingfixtures,thisLEDdrivercanonlybeusedbehindaswitchwithoutpermanentlyconnectedto
themains.
12.Theambienttemperaturederatingof3.5 /1000mwithfanlessmodelsandof5 /1000mwithfanmodelsforoperatingaltitudehigherthan2000m(6500ft).℃ ℃
13.ProductssourcedfromtheAmericasregionsmaynothavetheCCC/PSE/BIS/KClogo.PleasecontactyourMEANWELLsalesformoreinformation.
14.ForanyapplicationnoteandIPwaterprooffunctioninstallationcaution,pleasereferourusermanualbeforeusing.
https://www.meanwell.com/Upload/PDF/LED_EN.pdf
15.Whenthecurrentadjustmentismorethan110%oftheratedcurrent,itwillbeentertheProtectionstate.
File Name:XLG-240-SPEC 2019-07-12
EN55015(CISPR15),GB/T17743
EN61000-3-3
-----
-----
Class C @load≥50%
-----
EN61000-3-2 , GB/T17625.1
EN55015(CISPR15) ,GB/T17743