Datasheet

Wireless DC multi-channel PWM dimmer
WPD-06
Push dimming pairing
There are three independent Push dimming port in WPD-06.
1. Connect a 10-32V DC power/driver to CN0 using plug.
2. Connect at least one LED strip lamp to any channel using plug.
3. Connect a Push button between any Pin 4 or 5 or 6 and Pin 2(Ground) of CN9.
The following steps is assumed that one LED strip lamp connected to Channel 1 (CN1) and Push button between Pin 6 and Pin 2:
1) Long press L button on dimmer and LED connected to Channel 1 is now blinking. It means now Channel 1 is at pairing mode.
2) Press on Push button to pair it. First press on Push button is set to turn on Channel1. Second press on Push button is set to
turn off Channel1. The LED is blinking again.
Now this Push button is paired with Channel 1. In case there is another Push button/ batteryless switch needs to be paired, re-do the step 2).
3) Press L button on dimmer. The pairing is now moving to Channel 2. Any LED connected to Channel 2 is now blinking.
4) Press L button on dimmer. The pairing is now moving to Channel 3. Any LED connected to Channel 3 is now blinking.
5) Press L button on dimmer. The pairing is now moving to Channel 4. Any LED connected to Channel 4 is now blinking.
6) Press L button on dimmer. The pairing is now moving to Channel 5. Any LED connected to Channel 5 is now blinking.
7) Press L button on dimmer. The pairing is now moving to Channel 6. Any LED connected to Channel 6 is now blinking.
8) Press L button on dimmer to finish the pairing.
9) Now the system is set and ready to control the LED lamp on channel 1.
Dimming function:
Press the Push button to turn on the LED.
Press again and hold it till the light is dimmed to the level as request.
Release the Push button.
Input LED driver: Meanwell LPF-90-24
or any other DC source from 10 to 32Vdc
24V LED strip Lamp
CN1
Pin1
CN7 CN8
+-
CN9
Vin+Vin-Vin+Vin-
WPD-06