Datasheet

SPECIFICATION
MODEL SCP-35-12
DCVOLTAGE
RATEDCURRENT
CURRENTRANGE
PEAK5S Note.6
RATEDPOWER
OUTPUT
VOLTAGE ADJ.RANGE
LINEREGULATION Note.4
LOADREGULATION Note.5
SETUP,RISETIME
HOLDUP TIME (Typ.)
VOLTAGERANGE
FREQUENCY RANGE
EFFICIENCY (Typ.)
ACCURRENT (Typ.)
INPUT
FUNCTION
INRUSHCURRENT (Typ.)
LEAKAGECURRENT
SAFETY STANDARDS
EMCIMMUNITY
WORKINGTEMP.
WORKINGHUMIDITY
STORAGETEMP.,HUMIDITY
TEMP.COEFFICIENT
VIBRATION
MTBF
DIMENSION
OTHERS
NOTE
PACKING
OVERLOAD
OVERVOLTAGE
13.8V
2.6A
0~2.6A
3.1A
35.9W
120mVp-p
+15,-5%
± 2.0%
± 1.0%
± 2.0%
500ms,30ms/230VAC1200ms,30ms/115VAC atfullload
50ms/230VAC16ms/115VAC atfullload
85~264VAC120~370VDC
47~63Hz
16.6~19.3V
83%
0.75A/115VAC0.5 A/230VAC
COLDSTART 45A
<2mA /240VAC
3.1~4.2A ratedoutputpower
CompliancetoEN55022(CISPR22)ClassB,EN61000-3-2,3
CompliancetoEN61000-4-2,3,4,5,6,8,11,ENV50204,EN55024,EN61000-6-1,lightindustrylevel,criteria A
-20~+60℃ (Refertooutputloadderatingcurve)
20~90%RH non-condensing
-40~+85 ,10~95%RH℃
± ℃ ℃0.05%/ (0~45 )
10~500Hz,2G10min./1cycle,periodfor 60min.eachalongX, Y,Zaxes
523.3Khrsmin.MIL-HDBK-217F(25 )℃
FileName:SCP-35-SPEC2011-05-24
99*97*36mm(L*W*H)
0.37Kg;45pcs/17.7Kg/1CUFT
35WSingleOutputSwitchingPowerSupply
SCP-35 se rie s
WITHSTANDVOLTAGE
ISOLATIONRESISTANCE
I/P-O/P:3KVACI/P-FG:1.5KVACO/P-FG:0.5KVAC
I/P-O/P,I/P-FG,O/P-FG:100MOhms/500VDC/25 /70%RH℃
ENVIRONMENT
SAFETY &
EMC
(Note6)
PROTECTION
EMCEMISSION
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Line regulation is measured from low line to high line at rated load.
5. Load regulation is measured from 0% to 100% rated load.
6. 33% Duty cycle maximum within every 15 seconds. Average output power should not exceed the rated power.
7. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
℃
(As available on http://www.meanwell.com)
RIPPLE&NOISE(max.) Note.2
VOLTAGETOLERANCE Note.3
%
%
%
%
%
%
%
%
%
Universal AC input/Full range
Protections: Short circuit / Overload / Over voltage
Cooling by free air convection
100% full load burn-in test
2 years warranty
/ Battery
polarity protections (by fuse)
Built-in temperature compensation function
Output voltage detection signal
LED indicator for power on
No load power consumption <0.75W
■ Features :
Protectiontype:Hiccupmode,recoversautomaticallyafterfaultconditionisremoved
Protectiontype:Shutdowno/pvoltage,re-powerontorecover
UL60950-1,CB(IEC60950-1),CCCGB4943approved
1.4A
27.6V
1.7A
0~1.4A
38.6W
200mVp-p
± 1.0%
± 1.0%
± 1.0%
86%
1.7~2.3A ratedoutputpower
33.1~38.5V
SCP-35-24
+15,-5%
OUTPUTVOLTAGESENSOR
TEMP.COMPENSATION
ByNTC(notprovidewiththepowersupply)
L=outputvoltage+0.2~0.7V(ACOK);L=0V(ACFail)