Datasheet

(2)Insta ll Micr osoft Frame work4 (dotN etFx40_Full_x86_x64.exe).

(3)Con nect th e RKP-CMU 1 to your PC via a USB cable.

(4)Execute RKP-CM U1.exe.

Note: If ther e is the need for an updated Fra mework4 ve rsion, refer to Microsoft website .

http:// www.m icros oft.com /dow nload/ en/details.aspx?id=17851

6.2 Using RS23 2 for Communication wi th RKP-CMU 1

6.3 Descr iption of RKP-CMU1 Monitoring Sof tware

The RKP-CMU1 not only can use USB interface for PC connection , but a lso can use the RS-232 interface. There is a RS-232

1.In terface cable is connected between your PC and the RKP-CMU 1.

2.The RKP-CMU1 is powered on and ready.

3.Verify y our interface settings are correct. Refer to the LCD user interface (se ction 4.4.6)

6.3.1 Comm. Setup Page

Once this software is running, t here are some settings th at must be d one be fore a ccessing the RKP- CMU1 .

Step 1: COM Port Setting

1.Sel ect the corre ct port for yo ur interface c able.

2.Sel ect a proper baud r ate for data t ransmission . (Maximum: 115.2 k).

◎Before running the monito ring software , please make sure the following arrangement is done correctly.

port (Male) on the rear of the RKP-CMU1, you can use a DB9 Female - DB9 Female cab le for connection between the RKP-CMU1

and your PC. Pi n description shows as below.

Step 2: Address Se tting

Select the co rrect addres s for the RKP-CMU1. Refer to th e LCD user interface, Section 4 .4.9: RKP-CMU1 Addess

setting(Default:1).