User manual

1
PB-300,360 Instruction
Manual
1.Makesurethechargerisshutoffandchoosingsuitablewirestoconnectthechargerandbatteriesbasedontheratingofcharging
current. Thepolaritymustbecorrect:chargeroutput(+)shouldbeconnectedtothe(+)terminalofbatteriesandchargeroutput(-)
shouldbeconnectedtothe(-)terminal.
Innotimesshouldthe(+)and(-)beshorttogetherorthechargerandbatterieswillbedamaged.
2.Selectthecorrectinputvoltagerangebetween 115VACand230VAC. Theselectingswitchispresetat230VACinthefactory.
3.SettheON/OFF(0/-)powerswitchtoON(-)andcheckwhethertheoperationofLEDiscorrect(red:charging;green:batteryisfull).
1.Thechargerisonlysuitablefor"lead-acid"batteries.
2.The charger should be assembled in the place with good ventilation and low moisture. Exposure to the rain or snow is strictly
prohibited.
3.Wires connecting between the charger and batteries should be as short as possible since the high voltage drop on the wires will
increasethetimerequiredtofullychargethebatteries.
4.Makesurethechargingvoltageandchargingcurrentaresuitableforthebatteriesyouareusing.
AssemblyProcedure
NotesOnOperation:
:
BatteryConnection
LED
+V -V
Battery
DC(+)
WARNING:
Pleasemakesurethe
polarityofthebatteryis
connectedcorrectly!
DC(-)
ON/OFF 230/115VAC
SWITCH
INLET
3POLEIEC320C14
SWITCH
230
SVR1 CN5
Vadj
VR
RC