Datasheet

File Name:LCM-25KN-SPEC 2019-09-12
※PUSH dimming or AC/DC input monitor(Primary side)
‧The detail function of PUSH dimming, please refer to the database.
‧Up to 10 drivers can perform the PUSH dimming at the same time when utilizing one common push button.
‧The maximum length of the cable from the push button to the last driver is 20 meters.
‧The additive push button can be connected only between the PUSH terminal, as displayed in the diagram,
and AC/L (in brown or black); it will lead to short circuit if it is connected to AC/N.
◎ PUSH dimming
LCM-25KN
Push Button
AC/N (or Backup DC- input)
AC/L (or Backup DC+ input)
PUSH
AC/N
AC/L
◎ AC/DC input monitor
LCM-25KN
AC/N (or Backup DC- input)
AC/L (or Backup DC+ input)
PUSH
AC/N
AC/L
‧The detail function of AC/DC input monitor, please refer to the database.
‧KNX Bus need to connected when using AC/DC input monitor
DIMMING OPERATION
※ KNX interface
‧ Apply KNX Bus cable between KNX+ and KNX-
‧The application program(database) can be downloaded via Online Catalogs from ETS or via http://www.meanwell.com/productCatalog.aspx
DescriptionParametrization options
Switch functions ‧Turn on brightness
‧Dimming speed for turn on/off
‧Switch telegram and status
‧Switch on/off delay
Dimming ‧Dimming speed for 0~100%
‧Allow switch on via relative dimming
‧Push dimming with AC inut port
‧Block object for push dimming
Brightness value ‧Dimming speed for transition brightness values
‧Permit set switch on and off brightness via value
‧Brightness value and status
Fault message ‧Lamp fault
‧AC/DC input monitor fault messages
Other functions ‧Reaction on KNX voltage failure/recovery
‧Power-On level
‧Dimming curve select(linear/log)
‧Synchronous dimming output
‧Block function(Block1&Block2)
‧Staircase lighting function(multi-stage switch-off)
General function
‧Cyclic monitoring telegram(In operation)
8 Scenes
‧Recall and save via KNX with 8-bit telegram
Operating hours & CLO
‧Operating hours counter
Power consumption feedback
‧Power consumption report
‧Constant light out(5 scheduled divisions)
‧In case the PUSH dimming is set locally, up to 10 drivers can perform the PUSH dimming at the same time when utilizing one common push button.
‧In case the PUSH dimming is set independently via ETS, the number of drivers is done through group address and determined by the ETS project designer.
25W Multiple-Stage Constant Current Mode LED Driver
LCM-25KN series