Instruction Manual

Icon Atomic Time Reception Strength

Undefined data

No Reception for the past 24 hours

Weak signal, but can be decoded

Strong signal

Once the atomic time signal is received, the date and time will

be set automatically, and the [ ] icon will appear.

(Flashing)

• The atomic clock receiver is programmed that it will search for

the atomic time signal daily for 0:00, 3:00, 6:00, and 12:00 am.

• To enable or disable the atomic time receiver, press and hold

UP (? ) button for 3 seconds. If atomic time reception is

activated, a tower icon will start flashing. If reception is

disabled, the tower icon will disappear.

• If the time signal has not been received in 8 minutes, you may

set the time manually.

MANUAL SETTINGS

To select the time mode, press UP (? ) or DOWN (? ) until the

IN icon flashing with a beep sound alert. It is necessary to set

the desired US TIME ZONE.

TIME ZONE

• Press MODE button once to select hour and minutes with the

day of the week display.

• Select the Time Zone by pressing and holding UP ( ? ) button

for 3 seconds

• Keep holding UP (? ) button until the desired US Time Zone

(Pacific, Mountain, Central or Eastern) is highlighted on the

display’s US map, located to the right of the time display and

above the day of the week

• Release the UP (? ) button. The Time Zone is set