Specifications

Appendix F Command Set Description MX-2100/2104 Installation and Operation Manual
F-56 Commands
LOOP PRBS_INJ i:j <ENTER> or LP PRBS_INJ i:j <ENTER> (data channel only)
LOOP BERT i:j <ENTER> or LP BERT i:j <ENTER> (data channel only)
LOOP TONE_INJ i:j <ENTER> or LP TONE_INJ i:j <ENTER> (voice channel only)
ML RECOVERY
Purpose
When MX-2100 is configured for operation with manually controlled switched
backup or priority bumping (refer to DEF SYS command), this command is used to
initiate recovery from a priority bumping or switching to the backup link event,
and return to normal operation.
Format
ML RECOVERY <ENTER>
Use
• To initiate return to normal operation, type:
ML RECOVERY <ENTER>
MONITOR
Purpose
Select the desired I/O module channel for monitoring.
Format
MONITOR i:j or M i:j
Use
• To select a module channel, type:
MONITOR i:j <ENTER> or M i:j <ENTER>
where i is the number of the I/O slot number (1 through 12).
REBUILD FRAME
Purpose
Rebuild the MX-2100 frame.
The MX-2100 frame is updated according to the activated channels (in the order
they were inserted). When an I/O card is taken in/out, the frame is updated.
REBUILD FRAME should be used after a change in the MX-2100 channels.
Format
REBUILD FRAME [A] [B]
Use
• To rebuild the MX-2100 frame, type:
REBUILD FRAME [A] <ENTER> or REBUILD FRAME [B] <ENTER>
for ML-A channels or ML-B channels.