Specifications

MX-2100/2104 Installation and Operation Manual Appendix F Command Set Description
Commands F-25
DEF NP
Purpose
Define the configuration parameters of the network port.
The configuration parameters depend on the KCL.2 module version:
• For KCL.2 modules with RS-232 interfaces, this command is used to define the
communication parameters of the network port, select its operating mode
(network management access port or dial-out), and when applicable, control
the use of the call-out function. The communication parameters of the
network port can be different from the communication parameters of the
CONTROL port, which are selected by means of the DEF SP command.
• For KCL.2 modules with Ethernet interfaces, there is only the
ROUTING_PROTOCOL field.
Format
DEF NP
Use
1. Type:
DEF NP <ENTER>
If the KCL.2 module has an Ethernet interface, the following is displayed:
ROUTING_PROTOCOL
NONE
where NONE is the default value.
If the KCL.2 module has RS-232 interfaces, the following is displayed:
SPEED DATA PARITY CALL_OUT_MODE
9600 8 NONE NO
where the parameter values are the default values.
2. Change the parameter values as follows:
 Bring the cursor to the beginning of the first field to be changed by
pressing the space bar.
 To change the selected field, press F or B to scroll among the available
selections.
 When the desired selection is displayed, press the space bar to move to
the next field.
3. When done, press ENTER.
The second line of parameters is displayed. The following is a typical
display:
LOG_OFF AUXILIARY_DEVICE ROUTING_PROTOCOL
NO NMS_SLIP NONE
The network parameters and their values are listed in Table F-3: