Specifications

MX-2100/2104 Installation and Operation Manual Appendix F Command Set Description
Commands F-17
Table F-2. Dial-out Parameters (Cont.)
Designation Function Values
LOG-OFF Control the idle disconnect time. NO - Automatic session disconnect disabled.
10_min - Automatic disconnection after 10 minutes,
if no input data is received by the dial-out port.
AUXILIARY DEVICE Selects the management mode
supported by the dial-out port:
Note: At any time, only one of the
two ports of the KCL.2 module can be
used for management access.
NMS SLIP - The dial-out port connects to an SNMP
management station and/or TELNET host using the
SLIP protocol.
AGENT SLIP - The dial-out port is connected to
another agent port using the SLIP protocol.
NMS PPP - Same as NMS SLIP, except the PPP
protocol is used.
AGENT PPP - Same as AGENT SLIP, except the PPP
protocol is used.
ROUTING PROTOCOL Controls the transmission of routing
tables which allows management
traffic to be routed through the dial-
out port:
NONE - Routing not supported.
PROPRIET - Routing of management traffic by means
of the MX-2100 proprietary protocol.
DEF FRAME
Purpose
Define manually the allocation of bits in the main link frame. This activity is
necessary when a KDI module is used to bypass data between the MX-2100 main
links.
Manual allocation is enabled by means of the DEF SYS command.
The DEF FRAME command must be repeated after each change in the main link
data rate, and/or in the data rate of MX-2100 channels.
Format
DEF FRAME
Use
1. To perform manual bit allocation on the desired main link, type:
DEF FRAME A <ENTER> or DEF FRAME B <ENTER>
A typical DEF FRAME screen is shown below.
SLOT OPERATED_HIGHWAY SIZE DATA START
001 ML-A 013 000
006 ML-A 012 014