Specifications

MX-2100/2104 Installation and Operation Manual Appendix F Command Set Description
Commands F-13
Use
1. Type:
DEF CON <ENTER>
The main link selection screen is displayed. The screen lists the I/O slots
(including the options slot) and the main link currently used by each I/O
slot. A typical display is shown below:
KM2100.def con
I/O GROUP OPERATED_HIGHWAY PB[A–>B] PB[B–>A] SWITCH
============================================================================
OP ALL ML-A N/A N/A N/A
1 ALL ML-B N/A N/A N/A
2 ALL ML-A N/A N/A N/A
3 ALL ML-A N/A N/A N/A
4 ALL ML-B N/A N/A N/A
5 ALL ML-B N/A N/A N/A
6 ALL ML-A N/A N/A N/A
7 ALL ML-A N/A N/A N/A
8 ALL ML-A N/A N/A N/A
9 ALL ML-A N/A N/A N/A
10 ALL ML-A N/A N/A N/A
11 ALL ML-A N/A N/A N/A
12 ALL ML-A N/A N/A N/A
Checking Frame Structure…
Updating Frame Structure…
2. Use the space bar to move the cursor to the desired slot number, and press the
F or B key to change the main link used by this I/O slot.
If priority bumping is used, the third row shows the priority assigned to
each module when a flip occurs from main link A to main link B.
If priority bumping and switched backup are disabled, this row shows N/A
for all the I/O slots.
3. Use the space bar and the F and B keys to change the priorities as necessary.
A fourth row appears, showing the priorities for flips from main link B to
main link A.
 If the two main links operate at the same data rate or the switched
backup mode is used, MX-2100 automatically sets the same priorities
for flips in either direction. Then this line shows N/A for all the I/O slots.
 If the data rates of the two main links are different and the priority
bumping mode is used, you can select the priorities for each I/O slot
using the same procedure as above.