Specifications

Table of Contents
MX-2100/2104 Installation and Operation Manual vii
Table 5-1. Deactivating all the Tests................................................................................... 5-3
Table 5-2. Activating / Deactivating the Monitoring of a Selected Channel......................... 5-4
Table 5-3. Activating / Deactivating a Main Link Loop........................................................ 5-5
Table 5-4. Activating / Deactivating a Channel Loop .......................................................... 5-6
Table A-1. Common Logic Module KCL.2, Supervisory Port Connector Pin Allocations
for DCE Emulation.............................................................................................A-1
Table A-2. Common Logic Module KCL.2, Supervisory Port Connector Pin Allocations
for DTE Emulation .............................................................................................A-2
Table A-3. Common Logic Module KCL.2, MNG Connector Pin Allocations ......................A-3
Table A-4. Alarm Relay Connector Pinout.........................................................................A-4
Table B-1. LCD Alarm Messages ........................................................................................ B-1
Table C-1. IP Address Class................................................................................................C-5
Table E-1. System Parameters ............................................................................................ E-1
Table E-2. Main Link Parameters........................................................................................ E-4
Table E-3. Supervisory Port Parameters .............................................................................. E-7
Table F-1. Call-out Parameters......................................................................................... F-10
Table F-2. Dial-out Parameters ........................................................................................ F-16
Table F-3. Network Parameters....................................................................................... F-26
Table F-4. Terminal Programmed Parameters .................................................................. F-28
Table F-5. System Parameters .......................................................................................... F-30
Table F-6. MX-2100 Default Configuration Used with Supervision Terminal .................... F-53
Table F-7. Codes Used by Typical Terminals.................................................................... F-54