Technical information

HiTest Notes for Lotus Domino Windows NT Prioris MX 6–1

Problems and Solutions

This chapter describes problems encountered during the testing. Where appropriate, a solution

for each problem is given which provides a fix or workaround. An impact statement is also

provided.

Foundation Hardware

The following problems were identified:

Mylex PCI RAID Adapter

Problem

The Mylex PCI RAID Adapter fails to identify disks which are attached to it.

Impact

RAID cannot be used until the RAID configuration is saved as described in the

solution to this problem.

Solution

To resolve this problem, do the following:

1. Using the RAID configuration utility, save the existing RAID configuration.

This will reset the Mylex PCI RAID Adapter.

For more information on the RAID configuration utility, refer to the

RAID

Arrays 230/Plus Subsystem RAID Configuration Utility User’s Guide

2. Boot the Prioris MX 6200 system.

3. Insert the RAID Array 230/Plus SW RX23 diskette into your floppy drive.

4. Run RA200RCU.EXE.

5. Choose Controller Setup from the Main Menu of the RAID Controller Utility

(RCU).

6. Choose the default settings for hardware parameters, data parameters, SCSI

transfer parameters, and startup parameters.

7. Press ESC to exit. If you change settings, RCU prompts you to save the

altered controller configuration.

8. From the menu, select the disks that you want to configure and configure

them as RAID or JBOD.

9. Save the altered controller configuration if the RCU prompts you to do so.