Specifications

8
Display (LCD)
Bar graph, receive mode: Shows RX signal
strength in S-units (S-meter). If CWT is turned
on, the right half of the S-meter becomes a tuning
aid (pg. 13). Reducing RF gain adds a moving
reference segment (pg. 12).
Bar graph, transmit mode: Shows antenna
SWR and RF output (pg. 14). In voice modes,
shows CMP (compression) and ALC (mic level)
when mic gain or CMP are set (pg. 15). ALC
scale also used to set DATA audio level (pg. 18).
VFO Icons: Shows that a VFO or menu
entry is locked. The TX icon points to the transmit
VFO:
VFO A is the transmit VFO
VFO B is the transmit VFO; see
VFO A
VFO B
Filter Passband Graphic: Shows location
of receive filter passband (pg. 12)
Filter Icons:
NTCH Auto or manual notch (NTCH, pg. 13)
Manual notch (NTCH, pg. 13)
I / II PBT filter function (I/II, pg. 12)
XFIL Filter (FL1-FL3 used, pg. 12)
Mode Icons
Basic modes (LSB or USB, CW, DATA, AM, or
FM) are selected by tapping MODE . Alternate modes
(CW REV, DATA REV, AM-S, FM +/-) are
selected by holding ALT. LSB and USB are alternates
of each other. In SSB mode, the + icon indicates
ESSB (pg. 22). T indicates FM PL tone (pg. 15) or
CW/DATA text decode (pg. 19).
Other Icons:
CWT CW/data tuning aid on (CWT, pg. 13)
Message play/rec (MSG / REC, pp. 16, 21)
VOX VOX enabled (VOX, pp. 15, 16)
QSK Full break-in CW enabled (DLY, pg. 16)
NB Noise blanker on (NB, pg. 13)
NR Noise reduction on (NR, pg. 13)
ANT Antenna 1/2, KXAT100 (ANT, pg. 25)
RX Automatic RX attenuation in effect (pg. 13)
ATT Attenuator on (ATT, pg. 13)
PRE Preamp on (PRE, pg. 13)
ATU ATU enabled (ATU TUNE, pg. 14)
RIT RIT on (RIT, pg. 11)
XIT XIT on (X IT, pg. 11)
SUB Dual-watch enabled (DUAL RX, pg. 20)
SPLT Split mode in effect (SPLIT, pg. 19)
TX
A
TX
B
SPLIT