Product manual

KPMWC00905-10EN - page 12/24
Evaporator marine water box - Evaporator can be furnished with marine water boxes with victaulic or flanged
connections (on request). To save time and work marine water boxes cover can be easily removed to clean internal
tubes without the disconnection of water pipes.
Evaporator water side design pressure 21 bar
Condenser 1/3 passes - availability of these configurations must be checked on the selection software
Condenser flange kit - Condenser flanged connections (150 psi) are available instead of the standard victaulic
connections
Condenser double flange kit
Condenser marine water box - Evaporator can be furnished with marine water boxes with victaulic or flanged
connections (on request). To save time and work marine water boxes cover can be easily removed to clean internal
tubes without the disconnection of water pipes.
Condenser water side design pressure 21 bar
20mm condenser insulation
Cu-Ni 90-10 condenser tubes - To work with sea water the heat exchangers are fitted with Cu-Ni tubes and special
protection inside the end covers.
Evaporator/Condenser Flow switch – Supplied separately to be wired and installed on the evaporator water piping (by
the customer).
Suction line shut off valve – Installed on the suction port of the compressor to facilitate maintenance operation.
Energy Meter – This device allows to measure the energy absorbed by the chiller during its life. It is installed inside the
control box mounted on a DIN rail and show on a digital display: Line-to-Line Voltage, Phase and Average Current,
Active and Reactive Power, Active Energy, Frequency.
Rubber type antivibration mounts – Supplied separately, these are positioned under the base of the unit during
installation. Ideal to reduce the vibrations when the unit is floor mounted.
Sound proof system - - Made of sheet metal and internally insulated, the cabinet is "integral kind" ( around the whole
chiller, not only around the compressors ) to reach the best performance in noise reduction.
Witness test – Every unit is always tested at the test bench prior to the shipment. On request, a second test can be
carried out, at customer’s presence, in accordance with the procedures indicated on the test form. (Not available for units
with glycol mixtures).
Acoustic test