Installation manual

Page 8 IM-487
Control Locations
All controls are optional. If controls are ordered, Figure 6
shows the locations of various control components mounted
throughout the unit. See “Control Panel Locations” on page 9
for the locations of control components mounted in control
panels. Additional information is included in Table 2 on
page 13 and the wiring diagram legend at the beginning of
“Wiring Diagrams” on page 48. Figure 6 shows the blow-
through heat and blow-through coil sections. These sections
are also available in the draw-through position. All controls
mounted in the blow-through section would be located in the
same position within the draw-through section.
Figure 6. Control Locations
Note: See the wiring diagrams legend at the beginning of “Wiring Diagrams” on page 48 for designation /description.
Return Air
Economizer
Filter
Section
Supply
Fan
Section
AC1
(Optional)
Heat
Section
DX
Section
Discharge
Plenum
Section
AC1
(Optional)
SD2
(Optional)
RAT
LT11
(Optional)
S11, REC11
OEA
ACT3
PC5
S10, REC10 (Optional)
LT10 (Optional)
HL22 (Optional)
PC7
EAT
SD1 (Optional)
VM1 (Optional)
DAT
CAT
SV6 (Optional)
SV5 (Optional)
SV1
SV2