Installation manual

Page 4 IM-487
Typical Component Locations
Figure 1 shows a typical Blow-Through unit with the loca-
tions of the major components. Figure 2 on page 5 shows a
typical Draw-Through unit with the locations of the major
components. These figures are for reference only. See the
certified submittals for actual specific dimensions.
Figure 1. Blow-Through Configuration (Unit Size 077C Shown)
Bottom Return
Air Opening
Optional Outside &
Return Air Dampers
Condensate
Drain Connections
Bottom Discharge
Opening
Control Entrances
Power Entrances
Elevation
Plan View
Optional Exhaust Dampers
Optional Return Air Fan
Supply Air Fan
Cooling Coil
Discharge Plenum
Main Control Panel
(Optional)
Heat Section (Natural Gas, Steam,
Hot Water, Electric)
Filter Section
Optional Outside Louvers
(Both Sides)
Optional Back Return Air
C
D