Installation manual

IM-487 Page 21
Step 3.
Caulk and install parts as shown in Figure 21.
Figure 21. Reassembly of Split Units - Step 3
Step 4.
Install Raceway Cover as shown in Figure 22.
Figure 22. Reassembly of Split Units - Step 4
Note: Use the diffuser in a blank heat section or in a steam
heat and hot water heat section only.
Step 5.
Make electrical connections.
Reinstall Top Cap
saved from step 1
Caulk Ends of
Splice Cap
Splice Cover
Provided
#10 Screws
Provided
Nut Clip-on
Provided
Caulk
Vertical
Seam
INSTALL SCREWS
(.25 - 20 X .75)
SAVED FROM STEP 1
SEE DETAIL BELOW
If applicable install
as shown with
fasteners provided.
Inner Raceway Cover
is to be installed after
wires are routed
(Note: See Step 5)
3.72 ref.
(94 mm)