Specifications

IM 934-5 Page 31 of 48
3.5 To advance to the next screen, press SLEEP
( ) button. Starting time will ash. Adjust the
starting time by pressing or buttons.
DAY 1
AM
8:00
MORN
3.6 To advance to the next screen, press SLEEP
( ) button. Heat temperature will be displayed.
Adjust the heat setting with and buttons.
DAY 1
HEAT
AM
8:00
MORN
70
o
3.7 To advance to the next screen, press SLEEP
( ) button. Cool temperature will be displayed.
Adjust the cool setting with and buttons.
COOL
DAY 1
AM
8:00
MORN
78
o
3.8 To program the thermostat for each period of the day,
repeat steps 3.3 through 3.7.
Further, the thermostat can be programmed for each
individual day of the week or use the Simpleset
TM
feature as described below.
3.9 Simpleset programming is a convenient method of
programming the thermostat. Once the entire Monday
(Day 1) schedule is set, Simpleset programming
will copy the Monday schedule to every day of the
week. After completing Monday schedule, “day 2”
will appear on the screen. Press Down button once
to get to “day 1.” By pressing Down button for 3
seconds, days of the week will count down from 7
to 1 and settings are memorized. Once the schedule
is locked in, go through each day of the week and
make changes as needed. This feature speeds up the
programming of the standard weekday/weekend
schedule.
3.10 To exit the program mode, press MODE ( ) and
SLEEP ( ) buttons simultaneously for 5 seconds.
3.11 After exiting the program mode, select the mode of
operation and activate the program mode by pressing
the PROG ON/OFF button.
After a power outage, programmed daily settings will be re-
tained in memory. However, the clock must be reset to the
current time for the programmed daily settings to resume the
correct schedule of operation. See Clock Set Menu instructions
to reset the time and day of week.
NOTICE
2.3 To view the upper operating temperature limit (heat
maximum set point) press MODE button. HEAT will
be displayed. An example of what can be displayed:
2.4 To adjust the upper operating temperature limit (heat
maximum set point) press and hold the Fan Speed
button, and repeatedly press or buttons. The
max and factory default setting is 85°F (30°C). When
Control selection jumper on control board is set for
“T’STAT,” the max setting can go up to 90°F (32°C).
2.5 By pressing MODE button repeatedly from the
previous screen, the following will be displayed in
sequence:
• Indoor air sensor reading
• Indoor coil sensor reading
• Outdoor air sensor reading
• Outdoor coil sensor reading
2.6 Exit the conguration mode by pressing and
buttons for 5 seconds
3.1 The touchpad of the electronic controller can be
programmed for four time periods, MORN, DAY,
EVE, and NITE that are customizable for each day
of the week. Each period will have a start time, heat
and cool temperatures. The unit will monitor the day
and time, while maintaining the specic conditions
for each period of the day. During programming, the
item that is ashing is adjustable.
3.2 To enter the program menu, press SLEEP ( ) and
MODE ( ) buttons for 5 seconds.
3.3 By pressing SLEEP ( ) display will show the day
screen as shown below. Press or button to
change the day to program. To advance to the next
screen, press SLEEP ( ) button. To return to the
previous screen, press MODE ( ) button.
DAY 1
3.4 By pressing or button, the period of the day
will change.
MORN