Specifications

IM 934-5 Page 11 of 48
3. Drill two (2) 5/32" pilot holes for the mounting screws.
These holes can be located using the drain kit as a
pattern.
4. Assemble the drain kit as shown in Figure 11 and
securely fasten it to the wall sleeve with the screws
provided. Use either the 90
o
elbow or 6" straight tting
as required.
5. Install the wall sleeve by referring to the instructions,
"Installing Wall Sleeve" on page 12.
Note: Whenusingtheexternaldrainkit,thesleevemust
beushorbeyondtheoutsidenishedwall(donot
recess).
External Drain Kit
1. Assemble the drain kit as shown in Figure 12.
2. Choose the side of the wall sleeve to which the drain kit
is to be installed.
3. There are drain holes and pilot holes provided in the wall
sleeve from factory. Place the drain kit against the chosen
drain hole and fasten securely with screws provided. Use
either the 90° elbow or 6" straight tting as required.
4. Cover the unused drain hole with the block off plate and
gasket supplied with the drain kit.
Installing Condensate Drain Kit(s)
Alternate 6" Long, 1/2"
O.D. Straight Copper Tube
External Drain Kit
Indoor Drain Kit
Figure 11 illustrates the installation of the indoor drain kit.
The indoor drain kit must be installed before placing the
wall sleeve into the opening.
Indoor Drain Kit
1. Locate the drain so that it will be on the room side of the
wall when the wall sleeve is installed.
2. Drill a 1/2" diameter hole in the base of the wall sleeve
for the drain.
Figure 11: Indoor Drain Kit
Contractor To Drill
Three (3) Holes To
Accept Drain Kit
Square Drain Holes
Neoprene Sponge Gasket
Steel Mounting Plate
See Detail
Room Side
Gasket
Cover
Plate
Tube
Screws
Cover
Plate
1/2"
(13mm)
O.D.
Cabinet
Bottom
Detail