Technical data
8 OM 1191
Start Up
Figure 3: Start-Up By Changing the Parameters Individually
To change the parameters, follow these steps:
1 Select MENU to enter the main menu.
2
Select the Parameters mode with the UP/DOWN buttons
and select ENTER to select the Parameters mode.
3
Select the appropriate parameter group with the UP/
DOWN buttons and select SEL
4
Select the appropriate parameter in a group with the UP/
DOWN buttons. Select EDIT to change the parameter
value.
5
Press the UP/DOWN buttons to change the parameter
value.
6
Select SAVE to store the modied value or select
CANCEL to leave the set mode. Any modications not
saved are cancelled.
7
Select EXIT to return to the listing of parameter groups,
and again to return to the main menu.
To complete the control connections by manually entering the
parameters, see Parameters on page 12
For detailed hardware description, see the Technical Data on
page 82.
NOTE: The current parameter value appears below the
highlighted parameter.
To view the default parameter value, press the UP/
DOWN buttons simultaneously.
The most typical and necessary parameters to
change are parameter groups 99 Start-up data, 10
Start/Stop/Dir, 11 Reference Select, 20 Limits, 21
Start/Stop, 22 Accel/Decel, 26 Motor Control and 30
Fault Functions.
To restore the default factory settings, select the
application macro HVAC Default.
Start Up