Specifications

25
Safety Precautions
Precaution & Installation
Before installing the air conditioner unit, please read the following safety precautions carefully.
WARNING
Installation and maintenance should be performed by qualied persons who are familiar with local
code and regulation, and experienced with this type of appliance.
All eld wiring must be installed in accordance with the national wiring regulation.
Ensure that the rated voltage of the unit corresponds to that of the name plate before commencing
wiring work
According to the wiring diagram.
The unit must be GROUNDED to prevent possible hazard due to insulation failure.
All electrical wiring must not touch the refrigerant piping, compressor and any moving parts of the
fan motors.
Conrm that the unit has been switched OFF before installing or servicing the unit.
Before installing the air conditioner unit, please read the following safety precautions carefully.
CAUTION
Please take note of the following important points when installing
Do not install the unit where leakage of ammable gas may occur
If gas leaks and accumulates around the unit, it may cause re ignition.
Conrm drainage piping is connected properly
If the drainage piping is not connected perfectly, it may cause water leakage which will
dampen the furniture.
Do not overcharge the unit
This unit is factory pre-charged. Over charge will cause over current or damage to the
compressor.
Ensure that the unit panel is closed after service or installation.
Unsecured panel will cause unit to operate noisily.