Specifications

21
SLM Wired Controller (Model: M(4)RT055/060/080/100/120A/AR)
COOL
DRY
HEATMED
HIGH
AUTO
MODE
TEMP
SENSOR
ON/OFF
SLEEP
LOW
TIMER
8
2
5
9
3
6
4
1
FAN
FA NON/OFF
TEMP
SLEEP
TIMERMODE
7
1
2
3
4
5
6
10
7
SWING
SWING
FAN
SLM AC-5300(OPTIONAL)
Error Seven Segments
Room Sensor missing/Short
E1 blinking
Indoor coil sensor missing/Short E2 blinking
Outdoor coil sensor missing/Short E3 blinking
Compressor overload E4 blinking
Outdoor abnormal compressor
overload trip or gas leak
E5 blinking
Controllers
1. “ON/OFF” Switch
• Press to start the air conditioner unit.
• Press again to stop the unit.
2. Temperature Setting
• Set the desired room temperature.
• Press button to increase or decrease the
set temperature. Setting range are
between16ºC to 30ºC (60ºF to 80ºF).
3. Operation Modes
• Press the “mode” button for select the type
of operating mode.
- Cooling Only :
COOL, DRY, FAN
- Heat Pump :
AUTO, COOL, DRY, HEAT, FAN
(AUTO mode is represented by both
COOL and HEAT LED light on)
4. Fan Speed Selection
• Press the button until the desired fan speed
is achieved.
5. Timer
• Press the set button to select the switch
timer of the air conditioner unit (the
setting range is between 1 to 15 hours).
6. “SLEEP” Mode
• Press button to activate the sleep function.
This function can only be activated under
“cool” or heating mode operation. When it is
activated under ìcoolî mode operation, the
set temperature will increase 0.5oC after
30 minutes, 1ºC after 1 hour and 2ºC after 2
hours. If it is activated under “HEAT”
mode operation, the set temperature will
be decreased 0.5ºC after 30 minutes, 1ºC
after 1 hour and 2ºC after 2 hours.
7. Air Swing
• Press button to activate the automatic air
swing function.
8. Sensor
• Infra red sensor to receive signals from
wireless controller.
9. LED Display
• To display the set temperature (inºC) and
timer delay setting (in hours).
10. Transmission Source
• To transmit signals to the air conditioner.