Specifications

121
The design concept of the Condensing Unit is such that all servicing can be done from the front and side of the
unit.
Upon removal of front and side panel, all the electrical “terminal box”, fan and motor assembly and
compressor are easily accessible.
Under normal circumstances, these outdoor units only require a check and cleaning of air intake coil surfaces
once quarterly. However, if a unit is installed in area subjected to much oil, mist and dust, the coil must be
regularly cleaned by qualified Air Conditioner Service Technicians to ensure sufficient heat exchange and
proper operation. Otherwise, the systems life span might be shortened.
CAUTION
When the compressor is to be stopped for a long time, the crankcase heater should be energized for at
least 6 hours before start of operation.
Do not charge OXYGEN, ACETYLENE or other flammable and poisonous gases into the refrigeration
cycle when performing a leakage test or an airtight test. These types of gases are extremely dangerous,
because explosion can occur.
It is recommended that nitrogen or refrigerant be charged for these types of tests.
CAUTION FOR USE
Bear the following points in mind to safeguard against malfunction and breakdown.
Do not stick rods or other objects through the air outlet during operation since this may result to damage or
injury
The air conditioner must not re-start within 3 minutes after shutdown. (These models are equipped with a
crankcase heater with the compressor).
SerSer
SerSer
Ser
vicing vicing
vicing vicing
vicing
And MaintenanceAnd Maintenance
And MaintenanceAnd Maintenance
And Maintenance
Note: Avoid direct contact of any coil treatment material on the plastic part. This may cause plastic part
to deform as a result of chemical reaction.