Instruction manual

KOMAC00607-09EN 61

1 Oil Filter - 250mm

2 Oil Filter Housing Cover

3 O-Ring – 89.5x3

4 O-Ring – 76.1x3.4

5 M8 Bolts

• Unscrew and remove two hex head side cover bolts 180° apart. Insert M8 guide studs into the

vacant holes.

• Remove remaining bolts, remove oil filter housing cover.

• Pull the oil filter off of the spigot and withdraw the oil filter from the housing and clean.

• Clean oil filter housing cover plate.

Fitting a New Oil Filter Element – Reassembly

Before assembly commences, remove any paint from joint faces. Inspect parts individually for

damage, ensure they are completely clean before laying them out on a sheet of clean paper in

a logical order ready for reassembly.

Use fresh refrigerant oil to lubricate parts during reassembly. New O-rings must be used.

• Insert new oil filter into the housing, ensuring the filter sits tightly on the sealing spigot.

• Replace the oil filter housing cover

Filter housing cover plate – 6xM8 Bolts Removal of the filter housing cover

Sealing