Service manual

22 Service Manual SM-MDS_(i)

3.4.1 Wireless Handset G17

1. Transmission Source

2. Signal Transmission Indication

• Blink to confirm that the last setting has been transmitted to the unit.

3. Temperature Setting

• Temperature setting range is from 16°C to 30°C (optional setting 20°C to 30°C).

4. Personalize Setting

• Press and hold for 3s, then will blink. Press again to cycle between and ..

• Set the desire setting, then leave the handset for 4s without pressing any key and it will save the setting

into the program.

• Press

once to activate the P1 setting, press again to cycle between P1 and P2.

• Press any key to deactivate the personalize setting.

5. Automatic Air Swing (optional)

• Press the SWING

button to activate the automatic air swing function. Press again to stop the louver

at the desired direction.

6. Ionizer Function (For WM - G series only)

• Press

button to activate the negative ion function, which will refresh the indoor air effectively.

7. Sleep Mode Setting

• This function is available under COOL, HEAT and AUTO mode.

• When under cooling mode, the set temperature is increased by 0.5°C after 30 minutes, 1°C after an

hour, and 2°C after 2 hours.

• When under heating mode, the set temperature is decreased by 1°C after 30 minutes, 2°C after an hour,

and 3°C after 2 hours.

8. Operating Mode

• Press the MODE button to select the type of operating mode.

• For cooling only unit, the available modes are: COOL, DRY and FAN.

9. Fan Speed Selection

• Press the button continuously will toggle the fan speed in the following order:

Low Med High Auto

• Stop pressing when the desired fan speed appears on the display screen.