Specifications

ManualsBrandsMcQuay ManualsAir ConditionerMCK020B

TEMPERATURE SETTING

• Set the desire room

temperature.

• Press button to increase

or decrease the set

temperature. Setting

range are between 16°C

to 30°C setting (60°F to

80°F)(Optional setting

from 20°C to 30°C).

• Press 5 or 6 button

simultaneously will toggle

the temperature setting

between °C and °F.

ON / OFF switch

• Press to start the air

conditioner unit.

• Press again to stop the

unit.

SIGNAL TRANSMISSION

INDICATION

• Blink to confirm the last setting

has been send to the unit.

FAN SPEED AND

VENTILATION MODE

SELECTION

• Press the button until the

desired fan speed is

achieved.

OPERATION MODES

• Press the “mode” button

for select the type of

operating mode.

• Cooling only unit:

Cool→Dry→Fan.

• Heating cycles:

Cool→Dry→Heat→Fan.

TIMER SETTING

• Press set button to

activate the timer setting

(from 1 hour to 15 hour)

of the air conditioning

unit. It will be in "On" or

"Off" condition after the

set time depending to

the current condition

(either from "On" to Off"

or vise versa)

• To cancel the timer

setting, press the button

continuously until the

timer display goes off.

SLEEP MODE

•

Press the button to activate sleep mode.

This mode can only be activated while in

cooling or heating mode operation. If it is

activated in “COOL” mode, the set

temperature will be increase 0.5°C after

minutes, 1°C after 1 hour and 2°C

after 2 hours.

AUTOMATIC AIR SWING

• Press the button to

activate the automatic air

swing function. The

swing angle ranging from

horizontal to 25° to

bottom.

ControllersControllers

TYPE OF CONTROLLER VS TYPE OF FAN COIL

MODELS STANDARD CONTROLLER OPTIONAL CONTROLLER

MCK020~050AW G6 WIRELESS CONTROL NETWARE 2 CW (WIRED CONTROLLER)

MCM020~050DW G6 WIRELESS CONTROL NETWARE 2 CW (WIRED CONTROLLER)

MCC010~060CW

NETWARE 2 CW (WIRED

CONTROLLER)

MDB075~150BW WITHOUT CONTROLLER -

SELF DIAGNOSIS TABLE

Wireless Wired

Power LED Other LEDs 7 Segment Display

Operation / Faulty Indication

Blinks 4 times Fan blinks E1 Blinking Room sensor contact loose / short

Blinks 4 times Sleep blinks E2 Blinking Indoor coil sensor contact loose / short

Blinks 1 time Cool blinks E4 Blinking Pipe water temperature fault

Blinks 2 times Cool & Fan blinks E6 Blinking Pump faulty

OPERATION GUIDE FOR G6