Operating instructions

Installation
Note: Installation is to be performed by qualified personnel who are familiar with local
codes and regulations.
WARNING
Sharp edges on unit and coil surfaces are a potential hazard to personal safety. Avoid
contact with them.
Handling
Be careful to avoid rough handling of the unit. Do not push or pull the unit from anything other than
the base. Block the pushing vehicle away from the unit to prevent damage to the sheet metal cabinet
and end frame (see
Figure 1).
To lift the unit, 2 1/2" (64mm) diameter lifting tabs are provided on the base of the unit. Arrange
spreader bars and cables to prevent damage to the condenser coils or cabinet (see
Figure 2).
Figure 1, Suggested Pushing Arrangement
Blocking is required
across full width
Figure 2, Suggested Lifting Arrangement
All rigging locations
must be used.
Spreader bars
required
(use caution)
Number of fans may vary
from this diagram. The lifting
method will remain the same.
Spreader bars
required
(use caution)
4 ACZ / AGZ-BM IMM ACZ/AGZ-4