Unit installation

IOMM ACZ1-2 ACZ 010A through 039A 39
Most menus containing setpoint values have several different setpoints shown on one menu.
When in a setpoint menu, the ENTER key is used to proceed from the top line to the second
line and on downward. The cursor will blink at the entry point for making a change. The
ARROW keys (now in the edit mode) are used to change the setpoint as described above.
When the change has been made, press the ENTER key to enter it. No setting is changed
until the ENTER key is pressed.
For example, to change the number of unit fans setpoint:
1. Press MENU key to go to the MENU mode (see Figure 12).
2. Press SET (the UP Key) to go to the setpoint menus.
3. Press SET FAN SP (the Right key) to go to setpoints associated with unit operation.
4. Since the first (or top) menu will be used, there is no need to press the DOWN key to
scroll down through other setpoint menus.
5. Press the ENTER key to move the cursor down from the top line to the second line in
order to make the change.
6. Use the ARROW keys (now in the edit mode as shown above) to change the setting.
7. When the desired value is achieved, press ENTER to enter it. The cursor will
automatically move down.
At this point, the following actions can be taken:
1. Change another setpoint in this menu by scrolling to it with the ENTER key.
2. Using the ENTER key, scroll to the first line in the menu. From there the ARROW keys
can be used to scroll to different menus.