Tus neeg siv phau ntawv

11-11-2020 manuals-backend.z-wave.info/make.php?lang=en&sku=MCOEMH8-FC
manuals-backend.z-wave.info/make.php?lang=en&sku=MCOEMH8-FC 4/7
Fan Speed setting
In normal display, press fan button to switch among the fan speed : Low, Medium, High, Auto ; Then press M, or wait for 15s to confirm the choice.
You can find further information in the device manual.
Parameter Setting:
Under the shutdown state, press & hold M to enter parameter setting menu. The password is 5138 and press M to enter.
Specification
Power Supply: AC85V~260V, 50/60HZ
Resistive Load: 3A
Self Consumption: less than 1W
Temperature Sensor: NTC 15K
Display Accuracy: 0.1°C
Working Environment: 0~55°C; less than 95% RH (Non-condensation)
Temperature Setting: 5~35°C (Adjustable)
Dimension: 86* 86*42mm
Hole Pitch: 60-65mm (86 Standard junction box)
Z-Wave Frequency: 868.42MHz (EU)
Quick trouble shooting
Here are a few hints for network installation if things dont work as expected.
1. Make sure a device is in factory reset state before including. In doubt exclude before include.
2. If inclusion still fails, check if both devices use the same frequency.
3. Remove all dead devices from associations. Otherwise you will see severe delays.
4. Never use sleeping battery devices without a central controller.
5. Dont poll FLIRS devices.
6. Make sure to have enough mains powered device to benefit from the meshing
Association - one device controls an other device