Installation manual

Page 25
Inhibiting a Channel
To Inhibit a Channel when Scanning:
1. The scan program is now running.
The Scan ALL run screen is displayed.
Press Stop.
2. The screen now displays the new scan
status:
Inhibit chXX, where XX was the channel
when Stop was pressed. Example: Ch25.
Press Select.
The scan program is now running again,
But channel 25 is now temporarily deleted
from the list of channels to be scanned, and
the radio will skip over channel 25 when
selecting channels during the scan process.
Channel inhibition can be applied to additional channels, and is performed exactly
as described in steps 1 and 2 above.
To restore the original 'Scan All' state (all channels scanned) press the Back key
then the Select key. Scanning is then resumed for all channels.
Running a Scan Program (1-9)
To Run a Scan Program (Scan Program 1 to Scan Program 9):
1. In standby screen, press Menu, then scroll
to Channel scanning and press Select.
2. Scroll to Run scan program and press
Select.
3. Display shows Scan: ALL.
Scroll to Scan: 01 (or to the Scan Program of
your choice. When the desired Scan Program
is displayed press Select to start the Scan
Program.
[See also also ‘Full Telephony Operations: Creating and Editing a Scan Program’
page 24.]
Scan:ALL stopped
Inhibit ch25 
Select Run
Scan:ALL run
Stop
24 Back
Scan:ALL run
Stop
26 Back
Channel scanning
Run scan program 
Select Back
Run scan program
Scan:
01
Select Back