User manual

9
2.2. SYSTEM OPERSTION
2.2.1. USER LOGIN
2.2.1.1 STARTING THE SYSTEM
To power the system ON/OFF:
Connect the power cable to the DC 12V port on the rear panel. At startup, the system performs a basic
system check and runs an initial loading sequence. After a few moments, the system loads a live display
view.
ATTENTION: By default, passwords are disabled on the system. You do not need to enter a
password when accessing any system menus. However, for security purposes, it is highly recommended to
enable passwords on the system using the Password Menu.
NOTE:
1) If there is no HDD in device, or the device didn`t read the HDD, or the HDD didn`t be formatted
it will display an 【H】 in the video preview interface.
2) You must format the HDD in the DVR before first using. The steps as follows: Main Menu >
Device>HDD management > format. After formatting, the system will restart.
2.2.1.2 SYSTEM LOGIN
Login the main menu: Right-click anywhere on the screen, it will pop-up a menu list, then select [main
menu]; If use remote controller or front panel, just press [MENU] button.
Username: Click the User Name drop-down box, select your user name. If you want to register another
user to login, please select [admin] to login, and choose:[Main Menu]-[System]-[Password], to open the
another user.
Password: Enter the correct password.
Note: The default system password is enabled, every time you boot into the system requires you to enter
the password for the user name to enter the system. (System Administrator [admin] default password is:
123456), or (default password of [user1] is: 123456)
2.2.2. GUI OPERATION
The main menu include “DISPLAY”, “RECORD”, “NETWORK”, “SEARCH”,“DEVICES”,and
“SYSTEM”.