User manual

19
CH01~CH04: click to pop up pull-down box to switch to other channel to carry out setting.
I/O ALARM: Each channel has an I/O status, that is, when an alarm triggered, it will activate the
corresponding channel to start alarm recording.
N.O: indicate I / O input level from high to low effective
N.C: indicate I / O input level from low to high effective
HDD LOSS:ON means it will trigger a alarm if there is no HDD, and it will display an 【H】
On the bottom left of channel 1 in the live view
No Space: ON: If the space less than 500M, there is a remark in live view: No enough space, please
change HDD after shutdown.
VIDEO LOSS: ON: when one channel has no video input, it will display “video loss”in live view.
ALARM CONTRL: There are alarm output, buzzer Durationand pre Rec four items.
● OUTPUT: when an alarm triggered, the alarm output time will be:
0 second、10 seconds,20 seconds,40 seconds and 60 seconds
● BUZZER: buzzer calling time setup when alarm triggered:OFF,10 seconds,20
seconds,40 seconds and 60 seconds
● DURATION.:post recording time setup: 30 seconds,1 minute,2 minutes and 5 minutes
● PRE REC:OFF/ON
2.2.3.3 PTZ SETUP
Move the cursor to【PTZ】（Icon with the orange box means that selected）,press【Enter】to enter into
setting interface, you can setup the parameters for each channel separately.
CH01~CH04: click to pop up pull-down box to switch to other channel to carry out setting.
PROTOCOL: select the protocol of different PTZ, there are two protocols to switch, and the default is
Pelco-D
BAUD RATE: select the different baud rate for your PTZ, there are 1200, 2400, 4800, ,9600,38400,57600
and 115200.
DATA BIT: there are 5,6,7,8 options to select, default setting is 8.
STOP BIT: there are 1and 2 to select, the default setting is 1.
PARITY: there are None/Odd/Even/Mark/Space to select, the default setting is none.
CRUISE: ON means open the scanning auto-cruise function for corresponding channel,
OFF means not open
ADDRESS: Fill the code of respective PTZ