Owner`s manual

9
McIntosh System Controller
1. Connect one end of a shielded 4 con-
ductor cable from the WK-4 Keypad
Connector to the 5-Pin Terminal Con-
nector Plug, refer to adjacent chart
along with pages 4 and 5 of this
manual. Connect the 5-Pin Terminal
Connector Plug to the Zone 1 5-Pin
Terminal Block Connector of the
McIntosh System Controller.
Note: Refer to “Important Information”
number 5 and 8 on page 5 when
connecting the keypads to a C39
or MX130. If the Keypad is used
in the same room as the System
Controller, it is important to
disable the Front Panel Sensor on
the Controller to prevent
interference.
Refer to the
System
Controller
Owner’s Manual
for additional
information.
How to Connect with the 5-Pin Terminal Connector
Keypad
Connecti on
Num ber
5-Pin Plug
Connection
Numbe r
Wire
Color
11
22
33
44
55
Keypad Connections
How to Connect with the 5-Pin
Terminal Connector
2. Connect the WK-3 Keypad in a similar
manner as above except connect the 5-
Pin Terminal Connector Plug to the
Zone 2 5-Pin Terminal Block Connec-
tor of the McIntosh System Controller.