Owner`s manual

14
How to Operate the WK-4 con’t
Note: This condition is usually caused by
either interruptions in AC power
and/or major changes in voltage.
How To Set the Keypad Clock Time
Press and Hold the Clock push-button for
the entire time setting procedure:
1. Press and Hold the Hours push-button
until the display indicates the correct
AM or PM hour.
2. Press and Hold the Minutes push-but-
ton until the display indicates the cor-
rect minute.
3. Release the Clock push-button.
Note: If you wish to cancel the clock
setting and start over, press RESET
and hold for 3 seconds or more.
How To Set Sleep Time
Sleep times can be set from a minimum
of 10 minutes to a maximum of 60 min-
utes, in 10 minute intervals.
1. Press the Sleep push-button once. The
display will read 60 minutes and the
zone will turn on. By pressing the
Sleep push-button again (within 3
seconds) the display will indicate an
additional time reduction of 10 min-
utes for each press.
2. When the desired Sleep time is
reached the Sleep indicator on the
display will turn on and the clock will
return to the normal time display. The
system will stay on with the last
source selected for the set time and
then turn off.
3. If at any time you wish to cancel the
Sleep function, press Sleep again. The
zone will now turn off.
How To Set a Timed On-Off Event
Press and Hold the Set On push-button for
the entire time setting procedure:
Note: The On and Timer indicators on the
clock display will turn on.
1. Press and Hold the Hours push-button
until the display indicates the desired
AM or PM hour.
2. Press and Hold the Minutes push-but-
ton until the display indicates the cor-
rect minute.
3. Release the Set On push-button, the
On and Timer indicators turn off and
the starting time is now set.
Press and Hold the Set Off push-button for
the entire time setting procedure:
Note: The On and Timer indicators on the
clock display will turn on.
4. Press and Hold the Hours push-button
until the display indicates the desired
AM or PM hour.
5. Press and Hold the Minutes push-but-
ton until the display indicates the cor-
rect minute.
6. Press the Timer push-button to activate
the On/Off timed event function. The
TIMER indicator will turn on and the
signal source will turn on and off at the
set times.
Note: You can turn off the Timer mode by
pressing the Timer push-button again
and the Timer display turns off. All the
set on and off times will be retained in
memory for later use, or until they are
changed.