Owner`s manual

10
Keypad
Connecti on
Num ber
RJ45 Plug
Connection
Num ber
Wire
Color
15
24
32
41
52
Keypad Connections
McIntosh A/V Controller
1. Connect one end of a shielded 4 con-
ductor cable from the WK-3 Keypad
Connector to the RJ45 Connector
Plug, refer to adjacent chart along with
page 5 of this manual. Connect the
RJ45 Plug to the Zone A RJ45 socket
of the McIntosh A/V Controller.
Note: If the Keypad is used in the same
room as the System Controller, it
is important to disable the Front
Panel Sensor on the Controller to
prevent interference. Refer to the
A/V Controller Owner’s Manual
for additional information.
How to Connect with the RJ45 Connector
How to Connect with the RJ45
Connector
2. Connect the WK-4 Keypad in a similar
manner as above except connect the
RJ45 Plug to the Zone B RJ45 Socket
of the McIntosh A/V Controller.