Owner`s manual

14
How to Operate the
WK4 cont
4. Press and Hold the Minutes push-but-
ton until the display indicates the cor-
rect minute.
5. Release the Clock push-button. The
time is set and the clock will be run-
ning.
Note: If you wish to cancel the clock setting
and start over, press RESET and hold
for 3 seconds or more.
How To Set Sleep Time
Sleep times can be set from a maximum of
one hour, to a minimum of 10 minutes, in
10 minute intervals.
1. Press the Sleep push-button once. The
display will read 60 minutes and the
zone will turn on.
2. Press the Sleep push-button a second
time (within 3 seconds) and the dis-
play will read 50 minutes. Each addi-
tional time you press Sleep, the min-
utes display will indicate a time reduc-
tion of 10 minutes.
3. When the desired Sleep time is
reached, stop pressing the Sleep
pushbutton. The Sleep indicator on the
display will turn on to indicate that a
Sleep time has been set and the clock
will return to the normal time display.
The system will now stay on with the
last source listen to for the set time and
then turn off.
4. If at any time you wish to cancel the
Sleep function, press Sleep again, after
the clock display has returned to the
normal time indication. The zone will
then turn off.
How To Set a Timed On-Off Event
1. Press and Hold the Set On push-button
for the entire On time setting process.
The On and Timer indicators on the
clock display will turn on.
2. Press and Hold the Hours push-button
until the display indicates the desired
AM or PM hour.
3. Press and Hold the Minutes push-but-
ton until the display indicates the cor-
rect minute.
4. Release the Set On push-button, the
On and Timer indicators turn off and
the starting time is now set.
5. Press and Hold the Set Off push-button
for the entire Off time setting process.
The Off and Timer indicators on the
clock display will turn on.
6. Follow a similar process to set the off
time as done for the on time.
7. Press the Timer push-button to activate
the On/Off timed event function. The
TIMER indicator will turn on and the
signal source will turn on and off at the
set times.
NOTE: You can turn off the Timer mode by
pressing the Timer push-button again
and the Timer display turns off. All the
set on and off times will be retained in
memory for later use, or until they are
changed.