Owner`s manual

12
WK-4 Additional Functions
How to Operate the
WK-3 and WK4
How to Operate the WK-3 and
WK4
Input Push-buttons
Press to turn on a local zone and select a
desired signal source. The selected source
push-button will illuminate.
Note: Refer to figure 1 for the WK-3 and
figure 2 for the Wk-4.
Transport Operations
Press Play. Stop or Next (next track)/Rev
to operate a CD player Video disc player
or tape recorder.
Tuner Operations
When a McIntosh tuner is being used,
press Next/Rev (Review) to cycle through
the tuner presets.
System Off
Press the Sys Off Push-button to turn off
the entire system including the local zone.
Power
Press the Power push-button to turn On or
Off the local zone.
Note : When a zone is muted the Power
push-button blinks on and off. to
indicate muting is active.
Volume
Press an up or down Volume push-button
to raise or lower the volume in the local
zone.
Mute
Press the Mute push-button to mute audio
in the local zone. The Power push-button
will blink on and off to indicate muting is
active. Press again to unmute.
0-9 Numbered Push-buttons
Press a number push-button to operate the
optional McIntosh HC-1 Home Controller,
select tracks on a CD or laser video disc,
tuner presets or any numbered operation.
Tuner operations
Press AM or FM to select the desired
broadcast band. Press Channel up or down
to tune up or down the broadcast band.
Press Review to cycle through the tuner
presets.
Transport Operations
Press Stop, Back (backtrack), Next (next
IR Sensor
Aim a Remote Control
toward the built-in sen-
sor to perform operat-
ing functions.
Figure 1
WK-3