Owner`s manual

27
Location Default Setting New Setting
Left Front 10 feet
Center 10 feet
Right Front 10 feet
Right Surr 10 feet
Right Back Surr 10 feet
Left Back Surr 10 feet
Left Surround 10 feet
Subwoofer 10 feet
Loudspeaker Time Delay
How to Adjust Speaker Time Delay
The following Time Delay Adjustments will electronically
compensate for different Loudspeaker distances from the
Listening/Viewing Area. Refer to figure 9. Time delay is
measured in feet. The delays can be adjusted from 1 feet to
20 feet in one foot increments for each Loudspeaker.
Note: Before performing the TIME DELAY adjustments, you
must first have completed the SPEAKER SIZE
adjustments.
1. Press and hold the Front Panel SETUP Push-button ap-
proximately three seconds to enter the Setup Mode.
The word SETUP will appear on the MX134 Front
Panel Display and the MAIN SYSTEM SETUP Menu
will appear on the Monitor/TV screen. Refer to figure
6 on page 23.
2. Using the Up or Down directional push-buttons,
select Speaker Time Delay on the On-Screen Menu,
followed by the SELECT Push-button on the Remote
Control. Refer to figure 10.
Note: The very first time the SPEAKER TIME DELAY
MENU is accessed, the factory default settings will be
indicated.
3. Measure the distance from the Listening/Viewing Area
to each of the Loudspeakers. A table has been provided
to record the measurements and settings.
Note: A distance measurement that contains fractions of a
foot, should be rounded up or down to the nearest
whole number for this procedure.
4. Select the appropriate Loudspeaker location and type
by using the Up or Down directional push-buttons
to select first the menu item and then press the Left
or Right directional push-buttons to change the cur-
Figure 10
MENU: SPEAKER TIME DELAY
LEFT FRONT 10FT
CENTER 10FT
RIGHT FRONT 10FT
RIGHT SURROUND 10FT
RIGHT BACK SUR 10FT
LEFT BACK SUR 10FT
LEFT SURROUND 10FT
SUBWOOFER 10FT
MAIN MENU
rent setting. When all of the settings on the SPEAKER
TIME DELAY MENU agree with the Loudspeaker
measured distances in your Home Theater System, se-
lect MAIN MENU. The MAIN SYSTEM SETUP
Menu will reappear on the Monitor/TV screen.
5. Continue next to the SPEAKER LEVEL Settings. If
you do not wish to perform SPEAKER LEVEL Adjust-
ments at this time, select MAIN MENU from the
menu. The MAIN SYSTEM SETUP Menu will reap-
pear on the Monitor/TV screen and proceed to the next
step.
6. Select EXIT from the MAIN SYSTEM SETUP Menu.
If you are satisfied with the changes that you may have
made, select YES to save those changes or NO not to
save them. The MX134 will then return to normal op-
eration. Refer to figure 7 on page 26.
Figure 9
SETUP, con’t