Owner`s manual
14
1. Press a Program push-button for the zone you wish to
turn on and program. The LED next to the selected
zone will turn on.
Note: After pressing a Program push-button, you must make
any programming selections with 10 seconds of each
other. If no further selection is made within 10 seconds,
the zone programming will turn off and the CR12 front
panel reverts to Zone 1 control. If the zone is already
turned on when programming is initiated, the zone
audio will mute and any video signals will blank as
well.
2. Select a signal source for the zone by pressing any of
the eight signal source push-buttons. The selected sig-
nal source front panel LED will turn on for the zone
being programmed. This will become
the active signal source whenever
that zone is turned on.
3. Press an Up or Down Volume push-
button to select the desired volume
level in the zone being programmed.
The front panel display will indicate
the selected level.
4. Press Program again or wait 10 sec-
onds to exit the programming mode.
1. Press the Program push-button for the zone you to wish
change.
2. Press the push-button for the signal source whose LED
is currently illuminated. The entire row of front panel
signal source LEDs for that zone will turn off.
3. Press Program again or wait 10 seconds to exit the pro-
gramming mode.
4. The next time the zone is turned on it will come on
with the last selected signal source and volume level.
1. Press the Program push-button for the zone requiring
Accessory on.
2. Press the push-button for the signal source requiring an
accessory on command.
3. Press Accessory On to program a turn on signal. The
LED next to the Accessory On push-button will turn
On to indicate accessory on command has been se-
lected.
4. Press Program again or wait 10 seconds to exit the pro-
gramming mode.
Note: The accessory source component must have a Data
cable interconnected with the CR12 in order to receive
the turn on command and must also have a power
switch that automatically cycles off when AC power is
removed.
How to Program the CR12
Introduction to Programming
If no programming is performed, each zone will turn on
with the default tuner signal source at an indicated volume
level of 20. You can program a desired signal source and
volume level for each separate zone which will appear ev-
ery time that zone is turned on. It is also possible to change
programming so the zone will turn on with the last selected
signal source and volume level. You can also program a
compatible source component such as a CD player to turn
on and start playing when the zone is first turned on. It is
also possible to program accessory source function control
off for a zone which allows listening or viewing without
being able to operate accessory source component func-
tions. All programming is stored in permanent memory and
is retained until changed, even in the event of a power fail-
ure. Refer to Figure 5.
How to program a zone with the same signal
source and volume level
How to program a zone with the last selected
signal source and volume level
How to program Accessory On
Figure 5