Owner's Manual

10
INPUT
HDMI
OPT
AUX
H R 0 9 4
PHONO
INPUT Source Selection
Press this button to select
the desired program source.
Each press will advance
to another input.
NIGHT
Toggles the meter lights and
input LEDs on and off.
Selects Previous Track
with compatible
playback sources.
Play/Pause with compatible
playback sources.
Powers the RS250 on or off.
LED illuminates during the
time a remote command
is sent to the RS250.
Mutes and unmutes the audio
Decreases the volume level. Increases the volume level.
Selects Next Track
with compatible
playback sources.
LIP SYNC
These two buttons adjust
HDMI, USB or optically
connected audio up to
150ms to sync with video.
Descripon of Remote Control Buons
NOTE: the following additional discrete
commands for external control systems
are available:
POWER ON, POWER OFF, INPUT (Down),
AUX, PHONO, OPT (Optical), and HDMI.
Contact McIntosh Technical Assistance
or your dealer for more information.
Figure 9–
Remote Control Diagram
The Knobs and LEDs on the Front
The Right Knob The Right Knob is primarily
the Volume and Power Knob.
Command Right Knob Action
Raise Volume Rotate clockwise
Lower Volume Rotate counter clockwise
Mute/ Pause Short press (less than half a
second)
Unmute/Play Short press (less than half
a second) or rotate in either
direction
Adjust Bass
Level
Press and Hold while turning
clockwise to increase the Bass
Level and counter clockwise
to decrease. The Meter will
graphically show the level as
adjusted. The midpoint on the
meter is considered neutral
Enter Sleep State
(power down)
Press and Hold for two seconds
Wake from Sleep
State (power up)
Short Press
The Le Knob The Left Knob can be used to select
sources, lighting levels, and place the RS250 in Discovery
Mode.
Command Left Knob Action
Adjust
Lighting
Press and Hold while turning
clockwise to increase the lighting
level and counter clockwise to
decrease. The Meter will graphically
show the level as adjusted
Enter Bluetooth
Discovery Mode
Press and Hold for two seconds
Sleep Mode
Lighting
The Left Knob is used to change
wired inputs, adjust lighting, and to
place the RS250 in Discovery Mode.
Direct input access.
Press to go directly to the
indicated input.