Owner`s manual

8
How to Connect a
Two Way System
How to Connect a Two Way System
Left MN410,
MN510, or
MN610
Right MN410,
MN510, or
MN610
McIntosh Stereo
Power Amplifier
Left MS440,
MS540, or MS640
Right MS440,
MS540, or MS640
Right MS10Left MS10
+
-
+
-
Figure 9
BiAmp Jumpers - 6 dB Jumper
1. Press the connector ends of the supplied Woofer/
Midrange Red/Black cables onto the matching Woofer/
Midrange connecting lugs. Connect the Tweeters in a
similar manner.
2. Attach the tinned ends of the two Red/Black Woofer/
Midrange cables to the Crossover Network WOOFER
OUTPUT terminals. The Black wire connects to a MI-
NUS (-) terminal and the Red wire to a PLUS (+) ter-
minal.
3. Attach the tinned ends of the two Red/Black Tweeter
cables to the Crossover Network TWEETER terminals.
The Black wire connects to a MINUS (-) terminal and
the Red wire to a PLUS (+) terminal.
4. Connect the MINUS (-) OUTPUTS of a McIntosh
Power Amplifier to the MINUS SINGLE AMP
WOOFER INPUT Crossover Network terminals and
the PLUS (+) OUTPUTS to the PLUS (+) SINGLE
AMP TWEETER Crossover Network terminals.
5. An optional modification to the Crossover Network
produces a 6dB
reduction in
Tweeter level.
When facing the
terminal side of the
crossover, cut the
wire loop located
on the right side of
the crossover. Re-
fer to Figure 9.