Owner's Manual

20
by the track contained in the folder second. The Folder
Mode will play back the tracks contained in the se-
lected folder. Refer to figure 39.
1. Press the PLAY/PAUSEf/ Push-button to start
Playback. Refer to figure 40.
After all the tracks have been played the MCT450
will stop.
1RWH8VHWKHŸXSDQGźGRZQGLUHFWLRQDO3XVK
buttons to select folders on the disc.
'LVSOD\0RGHV
The MCT450 Front Panel Display indicates both track
number and playing time. There are three playing time
display indications: track elapse time, track remaining
time or disc remaining time. To change from the de-
fault setting of track elaspe time, press the DSP/TIME
Push-button on the Remote Control. Refer to figures
24, 41, 42 and 43.
'LVSOD\%ULJKWQHVV
There are four available Settings for the Front Panel
Display. The choices include three brightness settings,
KLJKGHIDXOWVHWWLQJPHGLXPRUORZDQGWKHGLVSOD\
may be switched Off. To change the brightness setting
perform the following steps and refer to figure 24:
1. Press the SHIFT Push-button.
0RPHQWDULO\SUHVVWKH',03XVK%XWWRQWR
change the current brightness setting. Repeat this
until the desired brightness setting is selected.
3. Press the DISC LAYER Push-button to store the
new brightness setting.
Power Mode
The MCT450 incorporates an Auto Off Feature, which
can automatically place the SACD/CD Transport into
WKH3RZHU6DYLQJ6WDQGE\2II0RGHGHIDXOWVHWWLQJ
This occurs approximately 30 minutes after there
has been an absence of a Digital Audio Signal. If it is
desirable to disable the Auto Off Feature, perform the
following steps:
1. Using the MCT450 Remote Control, press and
KROGLQWKH3RZHU3XVKEXWWRQIRUDERXW
seconds, at which time the Front Panel Display
indicates “Auto STBY Off”. Refer to figure 44.
2. The MCT450 will switch Off and the LED above
the STAND/BY Push-button will illuminate Red
LQFRORU3UHVVWKH3RZHU3XVKEXWWRQWR
switch the MCT450 On.
3. To re-active the Auto Off Feature, press and hold
in the Power Push-button on the Remote Con-
trol for about 5-10 seconds, at which time the Front
Panel Display indicates “Auto STBY On”. Refer to
figure 45.
How to Operate the MCT450, con’t
Figure 2
1 mp-3
Figure 39
Figure 40
4 2m15s
Figure 42
1 -2m35s
Figure 43
1 -51m33s
Auto STBY On
Figure 45
Auto STBY Off
Figure 44
Figure 41
1 1m35s