Owner's Manual

6
Connecons on the Back
The Inputs
Two Digital Coax Inputs
Two Digital Optical Inputs
One USB Audio Input
One 1/8-inch jack for RS232 connector
One 1/8-inch jack for wired IR Input
One AC power connector
One USB upgrade service port
One 1/8-inch Data Input jack (IN)
One 1/8-inch Power Control (trigger) Input (IN)
The Outputs
One Pair unbalanced RCA Output
One pair balanced XLR audio Output
One 1/8-inch Data Output jack (OUT)
One 1/8-inch Power Control (trigger) Output (OUT)
Making Connecons
Balanced/XLR Output
The Balanced Output (BAL L and BAL R) allows
the MCD85 to be connected to a Balanced Input
(typically a preamplier). To use the XLR output,
connect the BAL R to the right input of your
preamplier and BAL L to the preamplier’s left
input.
Below is the Pin conguration for the XLR
Balanced Input and Output Connectors on the
MCD85.
Figure 04– MCD85 Rear View