Specifications

The center position is the recommended setting for all
surround modes. In the CINEMA 1 (DOLBY PRO-LOGIC)
and CINEMA 2 (THX) modes the actual delay in
milliseconds is:
1 = 12.3mS
2 = 16.4mS
3 = 20.5mS
4 = 24.6mS
5 = 28.7mS
Any deviation from the center setting should be
determined by the listing position.
In the HALL mode the delay range is increased to
emulate the acoustics of various MUSIC HALLS, from
a night club to a stadium. The actual delay in
milliseconds is:
1 = 16.4mS
2 = 32.8mS
3 = 49.2mS
4 = 65.5mS
5 = 81.9mS
PUSHBUTTON SWITCHES
SUR CAL (Surround Calibrate)
The MX 130 has an integrated surround sound
calibrate system. Its mode of operation, MANUAL or
AUTOMATIC, is determined by a rear panel switch. In
the MAN mode each push of the button switches a
noise generator to a specific channel, LEFT FRONT,
CENTER, RIGHT FRONT, RIGHT SURROUND, LEFT
SURROUND, and SUBWOOFER in order. In the AUTO
mode the noise generator cycles through the channels
until the button is pushed a second time. If the MAIN
VOLUME CONTROL is changed during either mode,
calibrate is canceled. CALIBRATE operation is indicated
by an LED above the SUR CAL button.
SUR CAL OR
The SUR CAL (up) button increases the level of the
selected channel during CALIBRATE operation. The SUR
CAL (dwn) decreases the level. In the AUTO mode
the cycle is interrupted by pushing the SUR CAL or
SUR CAL button. However, 1 second after release
of the button the cycle will continue until the SUR CAL
button is pushed again or the MAIN VOLUME CONTROL
is changed.
SUR PRO (Surround Processor)
The SUR PRO push button is for switching the
surround processor in or out. When the MODE
SELECTOR SWITCH is in one of the surround sound
positions, the push button toggles the MODE between
standard STEREO and the selected surround operation.
ACCESS
The ACCESS push button operates the motor driven
door for ACCESS to the CAMCORDER INPUTS. When
the door is opened the V-AUX inputs are switched from
the rear to the front panel CAMCORDER inputs.
RECORD LOCK
This button disables commands from other areas so
recordings cannot be interrupted.
TUNE (UP) or (down)
Push (up) momentarily to tune up in frequency,
10kHz steps for AM or 100kHz steps for FM.
Push (up) and hold to tune up continuously.
Release the button when the desired frequency is
reached.
Push (down) in the same manner to tune down in
frequency.
AM/FM
Push the AM/FM button to change bands. The band
in use is indicated by an LED to the left of the frequency
display.
PRESET
Push momentarily to go to the next preset station.
Push and hold to scroll through the presets. The preset
station number is displayed on the left side of the lower
window.
ENTER
Push to select the preset station ENTER mode. The
MX130 will remain in this mode for 10 seconds. ENTER
mode is indicated by the LED above the pushbutton.
Follow the procedure described below for ENTERing
a station into memory.
1. Select band, AM or FM.
2. Using the TUNE buttons, TUNE to the desired
station frequency.
3. Push the ENTER button. The LED above the
button will turn ON.
MX 130 Product Preview/Page 7
MClNTOSH LABORATORY INC., 2 CHAMBERS STREET, BlNGHAMTON, NEW YORK 13903