Instruction Manual

Customer Helpline 0345 605 2062
16
WARNING!
In case of contact with detergents: rinse with an abundance of clean water
Always turn off the machine when changing the detergent bottle.
1. Unscrew the bottle cap of the detergent bottle. Fill the detergent to the detergent bottle.
Screw on the bottle cap tight.
2. Fit the detergent bottle to the trigger gun.
3. Turn on the pressure washer. Pull trigger to operate unit. The liquid detergent will
automatically mix with water, and be discharged through the nozzle. Apply detergent to a DRY
work surface, from bottom to top.
3. Rinse with clean water under high pressure (see step 3). On a vertical surface, rinse from
the bottom up, and then rinse from the top down to avoid streaking. Hold nozzle 6-8”
(15-20 cm) from the work surface at a 45
0
angle.
NOTE:
- Allow detergent to remain on the surface for a short time before rinsing. Do not allow deter-
gent to dry on surface
- When you have nished using the detergent injection system, ll detergent bottle with clean
water. Siphon water at low pressure for one minute, so that all detergent is ushed through
system. Remove detergent bottle, and rinse it until it is thoroughly cleaned.
Operate
Step 4 – Use the detergent bottle